GRAPHTEC FC 4500 Series - Adjusting Pen Exchange Position (Fc4500-50; 60 Only)

FC4500-UM-251-9370 124
7 ELECTRICAL SECTION
7.11 Adjusting Pen Exchange Position (FC4500-50 / 60 only)
Perform this adjustment when the Main Board or the Pen board or the Pen Block or the pen holder
assembly was replaced. And perform this adjustment when the position of Y relay board was changed.
Conrm the Pen Block is installing to the correct height.(See section 6.18.)
Input the factory recorded values if the Main Board was replaced only.
How to adjust the Pen Exchange Position
(1) Turn off the power if the power is on.
(2) Set the DIP switch to adjustment mode.
1
ON
OFF
2 3 4 5 6 7 8
(3) Turn on the power.
(4) Press the [Next Page] key until the following menu is displayed.
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
PEN EXCHANGE ADJUST
PRESS ENTER KEY!!
(5) Press the [Enter] key to display the following menu.
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
UP CHANG
Y=+000 H=+000
Each Function keys are corresponding to the following operations.
F1: Adjustment value is increased at the cursor position
F2: Cursor moves to left
F3: Plotter performs exchange action.
F4: Cursor moves to right
Upper Arrow: Adjustment value is increased
Lower Arrow key: Adjustment value is decreased