FC4500-UM-251-9370 123
7 ELECTRICAL SECTION
(11) Move the tip of pen position to the 0,0 position by using the position keys as shown in the following
picture.
Move the tip of pen position to the 0,0
position by using the position keys.
(12) Press the [Enter] key after the position was moved to the 0.0 position.
The following menu is displayed after the home position was set.
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
MOVE HOME POINT
PRESS ENTER KEY!!
(13) When this adjustment was nished correctly, press the [Next Page] key to display next adjustment
menu.
(14) You don’t need to perform the following steps if you want to continue to the next adjustment.
(15) Turn off the power.
(16) Set the DIP switch to the normal settings.
1
ON
OFF
2 3 4 5 6 7 8
To Next Page
Loading...
