GRAPHTEC FC 4500 Series - 10.3 Specifying the Cutting Conditions; 10.3.1 Specifying the Cutter Offset

FC4500-UM-251-9370 146
9 TROUBLE SHOOTING
9.5 Error Messages in GP-GL Command Mode
Error message Cause Solution
ERROR 1
Command Error
The plotter received an
unrecognizable command.
Press the plotter’s ENTER key.
When turning on the plotter to
which your software application
has output data, noise mixed into
the data input.
Your software application’s output
device setting has changed.
Congure your software application
menu to permit Graphtec plotter control.
Re-specify the software application’s
interface conditions.
The plotter’s interface conditions
have changed.
Re-specify the plotter’s interface
conditions.
ERROR 4
Parameter Overow
The numeric parameter of an input
command exceeds its permissible
range.
Congure your software application
menu to permit Graphtec plotter control.
Re-specify the software application’s
interface conditions.
Your software application’s output
device setting has changed.
The plotter’s interface conditions
have changed.
Re-specify the plotter’s interface
conditions.
ERROR 5
I/O Error
An error related to the receipt of
data occurred within the interface.
Congure your software application
menu to permit Graphtec plotter control
Re-specify the software application’s
interface conditions..
Your software application’s output
device setting has changed.
The plotter’s interface conditions
have changed.
Re-specify the plotter’s interface
conditions.