FC4500-UM-251-9370 137
7 ELECTRICAL SECTION
7.17 Resetting to the Factory Default Condition
When this function was performed the all condition settings are set to the Factory default settings.
How to reset to the Factory default settings
(1) Turn off the power if the power is on.
(2) Turn on the power while pressing the [Upper Arrow] key.
(3) The following menu is displayed.
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
DEFAULT SETTING
GP-GL(mm Japanese)
(4) Press the Upper Arrow Key or the Lower Arrow Key to select the default settings.
(5) Select the “HP-GL (inch English)” if the inch unit is used.
Select the “HP-GL (mm English)” if the mm unit is used.
(6) Press the [Enter] key after the default setting is selected.
(7) The following menu is displayed.
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
Execute?
YES NO
(8) Press the [F2] key to execute it.
(9) The plotter initialize to set the default settings.
To Next Page
Loading...
