FC4500-UM-251-9370 71
6 REPLACEMENT PROCEDURES
6.39 Front X Slider
How to detach the Front X Slider
(1) Detach the Corner Cover 50L (See section 6.6.).
(2) Detach the Corner Cover B (See section 6.7.).
(3) Detach the Corner Cover 50R (See section 6.8.).
(4) Detach the Corner Cover A (See section 6.9.).
(5) Detach the Panel R (See section 6.10.).
(6) Detach the Right Side Cover (See section 6.12.).
(7) Detach the Operation Panel (See section 6.15.).
(8) Detach the Operation Tray (See section 6.16.).
(9) Loosen the M4L8 TP head screw holding the Front X Belt Tension Bracket.
M4L8 TP head screw
Front X Belt
Front X Belt Tension Bracket
(10) Loosen the two M3L8 binding head screw adjusting the Front X Belt Tension.
Front X Belt Tension Bracket
Front X belt tension adjustment screw
(M3L8 binding head screw)
(11) Move the Y bar to the access hole of the Cap screw which is holding the Front X Belt Stopper plate
as shown in the picture below.
Front X Belt
Front X Belt Stopper Plate
Front X Belt Stopper Plate
There is access hole here.
M4L8 cap screw
Y bar
To Next Page
Loading...
