FC4500-UM-251-9370 125
7 ELECTRICAL SECTION
(6) Press the [F3] key and immediately press the [F3] key again and keep pressing [F3] key, then the
pen holder stops at the adjustment position as shown in the picture below.
Conrm the gap and the height at this time.
1.2 mm
Adjust the gap between 2nd Pen
holder and 2nd pen station to
become 1.2 mm.
Adjust the height of 2nd Pen
holder to 2nd pen station to
become same height.
2nd Pen holder
2nd Pen Station
(7) Adjust the Y (Gap between the 2nd pen holder and the 2nd pen station) and H (2nd pen holder
height) values by using the Function keys.
Adjust the Y value to adjust the gap to be 1.2 mm.
Adjust the H value to adjust the height to be same height to the 2nd pen station height.
(8) Attach the pen to the 2nd pen station after the H and Y values are changed.
(9) Press the [F3] key to conrm the pen exchange is performed correctly.
(10) When this adjustment was nished correctly, press the [Next Page] key to display next adjustment
menu.
(11) You don’t need to perform the following steps if you want to continue to the next adjustment.
(12) Turn off the power.
(13) Set the DIP switch to the normal settings.
1
ON
OFF
2 3 4 5 6 7 8
To Next Page
Loading...
