FC4500-UM-251-9370 131
7 ELECTRICAL SECTION
(23) Press the [Enter] key after the L adjustment value was input.
The following menu is displayed.
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
ORIGINAL CLEAR
ADJ.DRAW INPUT
(24) Press the [F2] key to draw the adjusted pattern to conrm the distance accuracy.
(25) Press the [Next Page] key to nish the adjustment if the measured distance has 500 mm x 400 mm.
(26) The next adjustment menu is displayed.
(27) You don’t need to perform the following steps if you want to continue to the next adjustment.
(28) Turn off the power.
(29) Set the DIP switch to the normal settings.
1
ON
OFF
2 3 4 5 6 7 8
To Next Page
Loading...
