GRAPHTEC FC 4500 Series - Page 119

FC4500-UM-251-9370 113
7 ELECTRICAL SECTION
(13) Move the tool position to a blank area of the copy paper by using the position keys.
(14) Press the [Enter] key. The plotter draws a square shape, reads it with a sensor, and adjusts the
position automatically.
(15) When adjustment was nished correctly the following menu is displayed.
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
LEV ADJ DRY TIME
P.AUTO P.MANUAL
(16) When adjustment is nished incorrectly the following menu is displayed.
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
SENSOR ERROR
Perform the following items if the above menu is displayed
Replace the pen to new one to draw good square.
Or readjust the registration mark sensor level.
And then readjust the registration mark sensor position.
(17) Press the [Next Page] key to display the following menu.
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
ARMS ADJUST
PRESS ENTER KEY!!
(18) You don’t need to perform the following steps if you want to continue to the next adjustment.
(19) When this adjustment was nished correctly, turn off the power.
(20) Set the DIP switch to the normal settings.
1
ON
OFF
2 3 4 5 6 7 8