GRAPHTEC FC 4500 Series - Page 12

FC4500-UM-251-9370 6
2 NAMES OF THE MAIN PARTS
FC4510-60
(1) Pen carriage : Drives the cutter/pen to the left/right.
(2) Pen holder : Holds the cutter/pen and drives it up/down.
(3) Y bar : Holds the pen carriage; moves left/right.
(4) Writing panel : Cutting/plotting is performed here.
(5) Control panel : Used to set and use the plotter’s various functions.
(6) USB interface : Used to connect the plotter to a computer by cable via the USB
interface.
(7) RS-232C serial interface : Used to connect the plotter to a computer by cable via the RS-232C
connector serial interface.
(8) AC line inlet : Connect one end of the power cord here and the other end to an
electrical socket.
(9) Power switch : Controls the on/off status of the power supply to the plotter.
Tool holder 1
Tool holder 2
Pen station
Tool holder 1 Tool holder 2
FC4500-50/60
FC4510-60
7
4
4
6
6
11
12
1
1
2
2
3
5
5
8
9
10
7
8
9
10