FC4500-UM-251-9370 120
7 ELECTRICAL SECTION
(22) Press the [F4] (+Y) key to display the following menu.
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
CHANGE TOOL
PRESS ENTER KEY!
(23) Move the tool position to a blank area of the copy paper by using the position keys.
(24) The plotter draws the cross mark target. Then the following menu is displayed.
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
CHANGE TOOL
PRESS ENTER KEY!
(25) Press the [Enter] key.
(26) The plotter will detect the cross mark target which is drawn by plotter with a sensor, and then plotter
draws the cross mark to the detected position.
Offset of Y direction
Cross Mark Target drawn by plotter
Offset of X direction
The plotter draws this cross
mark after the Cross Mark was
detected.
(27) The following menu is displayed.
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
SENSOR OFFSET ADJUST
X=0.00
mm
Y=0.00mm
(28) Measure the offset of X and Y, and then input the offset value for the X and the Y direction.
Press the [F2] key to select the X value at the above menu.
Press the [F4] key to select the Y value at the above menu.
The value can be changed by using up or down arrow keys.
Input the minus value when the drawn cross mark is shifted to the plus direction.
And you can input the factory recorded values for the Y of registration mark sensor at this times.
(29) Press the [ENTER] key after adjustment values were input.
(30) The following menu is displayed.
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
LEV ADJ DRY TIME
P.AUTO P.MANUAL
To Next Page
Loading...
