GRAPHTEC FC 4500 Series - 6.4 Front Y End Cover; 6.5 Rear Y End Cover

FC4500-UM-251-9370 14
3 THE TREE STRUCTURE OF MENUS
Procedure
Turn on the plotter while holding down the [Down Arrow] key to display the special functions menu on the
LCD.
In GP-GL command mode In HP-GL
TM
command mode
LANGUAGE SELECTION
[ English ]
LENGTH UNIT
• mm inch
; , : COMMAND
• ENABLED DISABLED
W COMMAND
TOOL UP TOOL DOWN
•
CONDITION PRIORITY
• MANUAL PROGRAM
LENGTH UNIT
• mm inch
MODEL EMULATED
• 7550 7595
CONDITION PRIORITY
• MANUAL PROGRAM
TOOL SELECT
• ENABLED DISABLED
INIT. BLADE CONTROL
• 2mm BELOW OUTSIDE
TOOL UP MOVE
ENABLED DISABLED
•
TOOL CHECK
• ENABLE DISABLA
BEEPER
• ENABLED DISABLED
TOOL SELECT WAIT
ENABLED DISABLED
•
CIRCLE RESOLUTION
AUTO DEFAULT
•
LISTING PREVENTION
ENABLED DISABLED
•
SWITCHING XY FORCE
ENABLED DISABLED
•
BEEPER VIEW =60min
VIEW TIME =30sec
TOOL SELECT WAIT
ENABLED DISABLED
•
LISTING PREVENTION
ENABLED DISABLED
•
SWITCHING XY FORCE
ENABLED DISABLED
•
BEEPER VIEW =60min
VIEW TIME =30sec
BEEPER
• ENABLED DISABLED
TOOL UP MOVE
ENABLED DISABLED
•
TOOL CHECK
• ENABLE DISABLA
INIT. BLADE CONTROL
• 2mm BELOW OUTSIDE
TOOL SELECT
• ENABLED DISABLED
LANGUAGE SELECTION
[ English ]
FC4500 only
FC4500 only
Press the [NEXT] key to cycle through the menus.
The currently selected setting is indicated by a black dot [•].
Press the [F2] or [F4] key to change the setting as required, and then press the [ENTER] key. To cancel
your selection and proceed to the next menu, press the
[NEXT] key.
If a black square (
) is d splayed, use the [ ] or [ ] key to change the numeric value and then press the
[ENTER] key to conrm your selection.
When you have nished setting all of the special functions, turn off the plotter.
• Your settings are registered in the plotter’s internal memory and retained even while the plotter is turned off.
• The special functions can also be set by selecting “Function”> “Special Functions” in the PAUSE menu.