FC4500-UM-251-9370 32
6 REPLACEMENT PROCEDURES
How to install the Pen Block
(1) Reattach the Pen Block in the reverse order in which it was detached.
(2) Adjust the Pen Block height when the two M4L8 binding head screws are tighten.
FC4500-50 / FC4500-60
Adjust the Pen Block height to the 10.5 mm from the Writing Panel as shown in the picture below.
And the bottom of Pen Block has to be parallel from the Writing Panel when the Pen Block height is
adjusting.
10.5 mm
FC4510-60
Adjust the Pen Block height to the 10 mm from the Writing Panel as shown in the picture below.
And the bottom of Pen Block has to be parallel from the Writing Panel when the Pen Block height is
adjusting.
10 mm
(3) Perform the Pen Pressure Adjustment when the Pen Block was replaced (See section 7.6.).
(4) Perform the Pen exchange position Adjustment when the Pen Block of FC4500-60 or the FC4500-50
was replaced (See section 7.11.).
To Next Page
Loading...
