GRAPHTEC FC 4500 Series - 6.43 How to Adjust the Rear X Slider Roller Horizontal Tension

FC4500-UM-251-9370 73
6 REPLACEMENT PROCEDURES
How to install the Front X Slider
(1) Reattach the Front X Slider in the reverse order in which it was detached.
(2) Adjust the Front X Slider Roller horizontal tension before installing the Front X Belt and the Y bar (See
section 6.40.).
(3) Adjust the Front X Belt tension after the Y bar was installed to the Front X Slider (See section 6.28.).
(4) Adjust the right angle of Y bar (See section 6.29.).