12 Working with Multi-Parts
Groove Synthesis
3. Use soft knobs 1-4 to adjust the tuning -50 to +50 cents for the indi-
vidual parts.
4. To toggle back to volume controls, press soft button 1 again.
To adjust the panning of each program in a multi-part:
1. Press the mode button.
2. Press soft button 2 (pan).
3. Use soft knobs 1-4 to adjust the volume for the individual parts. A
value of 0 (zero) is centered in the stereo eld. A value of -50 is panned
fully left. A value of +50 is panned fully right.
If Panning is set to 0 in the multi-part Panning menu, the front-panel pan
spread knob controls program panning instead of this the multi-part Panning menu.
In other words, if panning is set to 0 in the Mutlti-part menu, the pan spread knob
determines the panning for odd and even voices in a program. If the pan spread knob
is fully clockwise, each new voice played is hard-panned fully left or fully right. If the
pan spread knob is fully counter clockwise, all voices are centered in the stereo eld.
A setting in between these two extremes results in a smaller amount of left to right
panning as new voices/notes are played.
To copy programs between parts:
1. Press the mode button. The multi-part parameters appear in the display.
2. Press soft button 4 (parts).
3. Use soft knobs 1-2 to select the bank and program that you want to
copy from.
4. Use soft knob 3 to choose which part (1-4) you want to copy in the
selected program.
5. Use soft knob 4 to select the Part in the currently active program that
you want to copy the selected program/part to.
6. Once you’ve chosen the source program/part and which multi-part you
want to copy it to in the current program, press soft button 4 (copy).
To Next Page
Loading...