PEL-3000(H) User Manual
150
Power Source
Config Error
FSEQRS232
03/Oct/2018
OCP Test
0.00
V
0.000
A
0.00
w
Config Error
Config Error indicates that upon
starting the power supply voltage is
less than the Trig V voltage.
Set Curr: Fetch Volt:
Config Error indicates that the power supply
voltage is less than the Trig V voltage setting after
the test has started. This can indicate that the
power supply output is not on or that the power
supply output or Trig V is incorrectly configured.
In addition to the OCP settings as described above,
the Trig voltage settings must also be set according to
the output characteristics of the DUT.
To Next Page
Loading...
