Figure 4-97 Loitering Detection
Channel: Select the channel.
Enable: Loitering Detection enable toggle.
Schedule: Set the time slot to detect intrusion. You can take the setting of chapter
4.3.3.1 motion detection for reference.
Interval: Set the time interval of Loitering Detection triggered.
Action: Set the handling action of intrusion detection; please take the setting of
chapter 4.3.3.1 motion detection for reference.
You can add a virtual area to the surveillance area using the following steps:
1. Choose the area number, the maximum number of the area is 4.
2. Adjust the sensitivity. Range from 1-100. The higher the value is, the more easily the
detection alarm can be triggered.
3. Set detect time threshold. For example, if you set the time threshold to 5 seconds and
someone intrudes the pre-defined area for 3 seconds no alarm will be triggered, the
intrusion will have to occur for at least 5 seconds before an alert is activated.
4. Journey: 3 modes can be chosen in Loitering Detection, Offset, Weight and Journey. You can
choose one, two or all of them.
5. Click the Apply button to save the settings.
4.6.1.10 Parking Detection
Click on the " Event -> Alarm -> Parking Detection”, as shown in figure 4-98.
Parking Detection alarm is triggered when a car is parked in a pre-defined virtual region, and
some certain actions can be taken when the alarm is triggered.
To Next Page
Loading...
