Hammond A-405SP - Pedal Drawbar Parameters

59
Setting the Parameters
PEDAL DRAWBARS
7. TONEWHEELS
 is allows you to select the Tonewheel set (waveform) of the PEDAL Drawbars.
Normal: The traditional B-3/C-3 Tonewheel sound.
Muted: Analog-oscillating sound represented by the vintage Hammond X-5.
Synth1: Sawtooth waveform with sweep  lter.
Synth2: Dull square waveform.
8. ATTACK
 is allows you to set the Attack Rate and the Key-Click Volume at ATTACK and
RELEASE.
MAX CLK: Immediate attack and the key-click is loud.
NORM CLK: Immediate attack and the key-click is normal.
SOFT CLK: Immediate attack and the key-click is soft.
NO CLK: A slightly slower attack without key-click.
SLOW ATK: Slow attack without key-click.
9. DECAY RATE
 is allows you to determine whether the Pedal voice remains at the same volume as a
note is held, or if the voice decays, as like a plucked string.
 e setting range is 1 - 5 and C.  e higher the value, the longer the decay time.  ere
is no decay at C.
10. SUSTAIN LENGTH - DRAWBAR
 is allows you to set the Release Rate (= the decay time after you release the key), when
the [PEDAL SUSTAIN] button is ON.
1 is the shortest, and 5 is the longest decay time.
NOTE: You can locate this page by holding down the [PEDAL SUSTAIN] button as well.
11. SUSTAIN LENGTH - EXTRA VOICE
 is sets the sustain length for Extra Voice (P.76), when the [PEDAL SUSTAIN] button
is ON.
0 is the shortest, and 63 is the longest decay time.
Time
Loudness
Attack
Note On Note Off
Decay = "C"
Decay =
"1" - "5"
Sustain =
"On"
SUSTAIN
Unlike Synthesizer nomenclature, on the A-
405SP “Sustain” refers to note decay after note
release. On a synth envelope generator this
setting would be called “T4” or “Release”.
NOTE: All the parameters in these modes
are Preset Parameters. They are re-
corded into the Combination Pre-
set.