*#1 #52
Owner’s Manual
80
CHORUS
In this mode, you adjust the setting for the Chorus eff ect. Chorus aff ects only for the
Extra Voice division.
To locate this mode:
Touch the [MENU] button for the MENU, select page D by the [PAGE] button, and
then touch [2] CHORUS button.
EXTRA VOICE
1. LEVEL
is sets the Level of the Chorus eff ect.
e setting range is 0 - 127.
2. TYPE
is sets the Types of Chorus eff ect.
Chorus 1, 2, 3, 4:
These are conventional chorus e ects. They give spaciousness and depth to the sound.
FB Chorus:
This is a chorus that produces an e ect similar to a anger. It softens the sound.
Flanger:
This creates an e ect reminiscent of a jet airplane taking o and landing.
3. RATE
Sets the modulation frequency of the Chorus eff ect.
e setting range is 0 to 127. e higher the value, the faster the frequency.
4. DEPTH
Sets the modulation depth of the Chorus eff ect.
e setting range is 0 to 127. e higher the value gets, the deeper gets the modula-
tion.
5. FEEDBACK
Sets the amount of feed back of the Chorus eff ect output to the Chorus eff ect again.
e setting range is 0 to 127. e higher the value, the more feed back.
6. SEND TO REVERB
Sets the amount of the output of the Chorus eff ect to send to the Reverb eff ect.
e setting range is 0 to 127.
NOTE: CHORUS - TYPE is a macro parameter that allows global setting of chorus parameters.
When you select the CHORUS - TYPE, each chorus parameter (except #6) will be set to
the most suitable value.
NOTE: All the parameters in these modes are Preset Parameters. They are recorded into the
Combination Preset.
1 2 3 4 5 6
To Next Page
Loading...
Need help?
General
