65
Setting the Parameters
DAMPER
26. DAMPER - DRAWBAR (G)
27. DAMPER - EXTRA VOICE (G)
28. DAMPER - EXTERNAL ZONE (G)
is is for determining whether to send the Damper information to each section. e
combination of the foot switch and these Damper parameters decide on which part of
which section the Damper eff ect is added.
For example, if you want to add the Damper eff ect on the Extra Voices of the Swell
manual with the foot switch on the Expression Pedal, set FOOT SWITCH 1 - MODE
(#21) at “DAMPER SWELL”, and DAMPER - EXTRA VOICES (#26) at “ON”.
DISPLAY
29. DISPLAY - SHORT CUT (G)
It sets the time limit to the short cut function.
e range 0s to 2s and NO short cut. e short cut function does not work when the
value is in “NO”.
30. DISPLAY - TIME OUT (G)
It sets the time limit to return to the previous screen from the one displayed by using
the short cut operation.
e range is 4s to 16s and NO time out. e time out function does not work when
the value is “NO”.
COUPLER
31. COUPLER - HI KEY PEDAL TO GREAT (P)
is is used for determining the highest note on which the Pedal-to-Great will work.
is value is set also if you touch the desired note on the Great manual holding down
the [JUMP] button, instead of using the [VALUE] button.
NOTE: You can locate this page by holding down the [PEDAL TO GREAT] button as well.
32. COUPLER - HI KEY GREAT TO PEDAL (P)
is is used for determining the highest note on which the Great-to-Pedal function will
work. is value is set also if you touch the desired note on the Great manual holding
down the [JUMP] button, instead of using the [VALUE] button.
NOTE: You can locate this page by holding down the [GREAT TO PEDAL] button as well.
PEDALBOARD
33. PEDAL - KEY MODE (P)
is allows you to set the Pedal voice mode.
POLY: Makes is possible to play harmony (up to 8 notes).
MONO:
Only one note sounds. If multiple notes are played, only the last note depressed will sound.
NOTE: The previously released note will be cut when you touch the new one, even when the
PEDAL Part is in the POLY mode and SUSTAIN is ON.
NOTE: The parameters by the names with
(P) on the end are Preset Parame-
ters, and the recorded to each Com-
bination Preset. (G) is for “Global”.
These parameters will be recorded
when set, and are common in each
Combination Preset.
To Next Page
Loading...
Need help?
General
