79
Setting the Parameters
REVERB
In this mode, you adjust the setting for the Reverb eff ect.
To locate this mode:
1. Touch the [MENU] button for the MENU, select page C by the [PAGE] button, and
then touch [1] REVERB button.
2. Or, turn the [REVERB] knob with pressing the [MENU] button.
DRAWBARS
1. DEPTH
is sets the Depth (= volume) of the Reverb eff ect.
e setting range is 0 - 127. is parameter is linked with [RE-
VERB] knob.
2. TYPE
is sets the Types of Reverb eff ect.
Room 1: Inside the room (short)
Room 2: Inside the room (long)
Live: Live house
Hall 1: Concert Hall (long)
Hall 2: Concert Hall (short)
Church: Church
Plate: Iron-plate Reverb
Spring: Spring Reverb
Delay: Delay
PanDly: Panning Delay
RevDly: Reverb + Delay
3. REVERB TIME
When the Type (#2) is set at Room 1 to Plate, it sets the Time
for Reverb to fade out.
e setting range is 0 - 31. e higher the value, the greater the
impression of a larger building.
4. DELAY TIME
When the Type (#2) is set at Delay, PanDly, RevDly, it sets the
delaying time.
e setting range is 4.7 - 2000 ms. e higher the number, the
longer the delay gets.
NOTE: You can set the delay time with the foot switch (P. 64)
5. DELAY FEEDBACK
When the Type (#2) is set at Delay, PanDly, RevDly, it sets the
amount of the Feedback (the delaying sound repeats).
e setting range is 0 - 96%. e higher the value, the more
Feedback you get.
6. LESLIE ON REVERB
is sets the route of the Reverb and Leslie eff ect.
OFF: Leslie to Reverb
ON: Reverb to Leslie
NOTE: REVERB - TYPE is a macro parameter that allows global set-
ting of reverb parameters. When you select the REVERB
- TYPE, each reverb parameter (except #6) will be set to the
most suitable value.
EXTRA VOICE
7. DEPTH
is sets the Depth (= volume) of the Reverb eff ect.
e setting range is 0 - 127. is parameter is linked with [RE-
VERB] knob.
8. TYPE
is sets the Types of Reverb eff ect.
Room 1: Small room
Room 2: Medium room
Room 3: Large room
Hall 1: Medium Concert Hall
Hall 2: Large Concert Hall
Plate: Iron-plate Reverb
9. REVERB TIME
It sets the Time for Reverb to fade out.
e setting range is 0 - 127. e higher the value, the greater
the impression of a larger building.
NOTE: When you select the REVERB - TYPE, reverb time will be set to
the most suitable value.
PRESET PARAMETERS
Reverb is a Preset Parameter, designed to actively
use as one of the tone-making parameters. How-
ever, it is not practical to use Equalizer as a tonal
complementary tool to match the location. In
such a case, if you switch OFF the P. LOAD RV/EQ
in the PRESET function mode, the Equalizer value
does not change when the preset is recalled. (P. 60)
NOTE: All the parameters in these modes are Preset Parameters.
They are recorded into the Combination Preset.
1 2 3 4 5 6
7 8 9
To Next Page
Loading...
