Hioki 3227 - Page 108

96
────────────────────────────────────────────────────
8.4 Command Reference
────────────────────────────────────────────────────
Synta
x
:DSET:PARAmeter?
Functio
n
Returns the temperature conversion table setting set by ":DSET:TABLe", as
numerical value in NRf format (data).
Respons
e
If headers are ON
If headers are OFF
:DSET:PARAMETER data1,data2,data3
data1,data2,data3
Erro
r
When the temperature correction function is selected at power on, the
executed error is generated.
Exampl
e
If headers are ON
If headers are OFF
Transmission
Response
:DSET:PARA?
:DSET:PARAMETER 300E‑
3,20.0, 235.0
:DSET:PARA?
300E‑3,20.0,235.0
Synta
x
:DSET:TABLe data
dat
a
1 to 15 (numerical data in NR1 format)
Functio
n
Selects the temperature conversion table set by ":DSET:" command
Erro
r
When the temperature correction function is selected at power on, the
executed error is generated.
Exampl
e
Transmission
:DSET:TABL 1
After this transmission, the temperature conversion table number is 1 set
by ":DSET:" command.
:DSET:PARAmeter?
:DSET:TABLe