Hioki 3227 - Page 118

106
────────────────────────────────────────────────────
8.4 Command Reference
────────────────────────────────────────────────────
Synta
x
:TCSET data1, data2
dat
a
data1: standard temperature, data2: temperature coefficient
data1 = -10.0 to 99.9 (numerical data in NRf format)
data2 = -9999 to 9999 (numerical data in NRf format)
Functio
n
Sets the standard temperature and the temperature coefficient of the
temperature correction function.
Erro
r
When the temperature conversion is selected at power on, the execution
error is generated.
Exampl
e
Transmission
:TCSET 23.0, 3650
The standard temperature of the temperature correction function is set to
23.0℃, and the temperature coefficient of that is set to 3650 ppm (copper
wire).
Synta
x
:TCSET?
Functio
n
Returns the settings of the correction temperature and the temperature
coefficient of the temperature correction function, as a numerical value in
NRf format (data).
Erro
r
When the temperature conversion is selected at power on, the execution
error is generated.
Respons
e
If headers are ON
If headers are OFF
:TCSET data1,data2
data1,data2
Exampl
e
If headers are ON
If headers are OFF
Transmission
Response
:TCSET?
:TCSET 23.0,3650
:TCSET?
23.0, 3650
:TCSET
:TCSET?