Hioki 3332 - Page 129

115
────────────────────────────────────────────────────
8.4 Command Reference
────────────────────────────────────────────────────
■ Queries which the items of D/A output is to be performed
Syntax
AOUT?
Function
Returns the D/A output items as character data <A>.
Note
With this query, if any errors occurs, no response message is produced.
Response
syntax
Headers: ON
Headers: OFF
":AOUT_<A>"
"<A>"
Errors
･ Query error/ If the response message is longer than 1000 bytes.
･ System error/ This query is not executed. A device dependent error occurs.
Example
Transmission
Response
Headers: ON
Headers: OFF
":AOUT?"
":AOUT VA"
"VA"
■ Sets the number of measurements over which the averaging calculation is tobe
performed.
Syntax
AVERaging_<NR1>
<NR1>
1 to 300 (NR1 numerical value)
Function
･ Sets the number of measurements over which the averaging calculation is to be
performed.
･ <NR1> can be received in NRf format, but the decimal fraction is rounded
(rounding up a final 5).
Notes
･ When the averaging count is set, the measurement is restarted.
･ The AV indicator lights with setting other than 1, and it goes off with setting of 1.
Errors
･
Execution error/ If the setting data is other than listed above.
･
Command error/ If the setting data is not in NRf format.
･ Device dependent error/
① In the event of a system error
② If this command is executed in the hold state (HOLD indicator lit or
flashing)
Example
Transmission
":AVER 16"
The averaging count is set to 16.
AOUT?
AVERaging