Hioki 3332 - Page 130

116
────────────────────────────────────────────────────
8.4 Command Reference
────────────────────────────────────────────────────
■ Queries the number of measurements over which the averaging calculation is to be
performed.
Syntax
AVERaging?
Function
Returns the current setting of the number of measurements over which the
averaging calculation is to be performed, as a numerical value in NR1 format.
Note
With this query, if any error occurs, no response message is produced.
Response
syntax
Headers: ON
Headers: OFF
":AVERAGING_<1-300>"
"<1-300>"
Errors
･ Query error/ If the response message is longer than 1000 bytes.
･ System error/ This query is not executed. A device dependent error occurs.
Example
Transmission
Response
Headers: ON
Headers: OFF
":AVER?"
":AVERAGING 16"
"16"
■ Enables or disables the comparator function for channel 1.
Syntax
COMParator1_<ON/OFF>
Function
･ Enables or disables the comparator function for channel 1.
･ The channel number need not be specified, as channel 1 is presumed by
default.
･ When the comparator for channel 1 is set to all OFF, the comparator table
when this command is received is enabled.
Errors
･
Execution error/ If the setting data is other than listed above.
･
Command error/ If the setting data is not character data.
･ Device dependent error/ In the event of a system error.
Example
Transmission
":COMP1 ON"
Enables the comparator function for channel 1.
AVERaging?
COMParator1
(Short form: COMP1)