Hioki 3332 - Page 165

151
────────────────────────────────────────────────────
8.4 Command Reference
────────────────────────────────────────────────────
Errors
･ Query error/ If the response message is longer than 1000 bytes.
･ Execution error/ If this query is executed with character data other than above.
･ Device dependent error/
① In the event of a system error
② When it is out of range, when scaling error occurred, or no output data.
Example
Transmission
Response
Headers: ON
Headers:OFF
":MEAS? V,A,W?"
":V +150.00E+0;A +20.000E+0;W +3.0000E+3"
"+150.00E+0;+20.000E+0;+3.0000E+3"
■ Enables or disables the peak value hold function.
Syntax
PEAKhold_<ON/OFF>
Function
･ Holding of the peak display is enabled or disabled.
Errors
･
Execution error/ If the setting data is other than listed above.
･
Command error/ If the setting data is not character data.
･ Device dependent error / In case of system error, and during hold display state
(HOLD indicator lit)
Example
Transmission
":PEAK ON"
Enables the peak value hold function.
■ Queries whether or not the display of peak value is currently held.
Syntax
PEAKhold?
Function
Whether or not the display is currently held is returned as "ON" or "OFF".
Note
With this query, if any error occurs, no response message is produced.
Response
syntax
Headers: ON
Headers: OFF
":PEAKHOLD_<ON/OFF>"
"<ON/OFF>"
Errors
･ Query error/ If the response message is longer than 1000 bytes.
･ System error/ This query is not executed. A device dependent error occurs.
Example
Transmission
Response
Headers: ON
Headers: OFF
":PEAK?"
":PEAKHOLD ON"
"ON"
PEAKhold
PEAKhold?