37
────────────────────────────────────────────────────
4.3 Setting the Integration
────────────────────────────────────────────────────
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
(7) When the integrate value achieves ±999999 MAh (MWh) or when the
integrate time achieves 10000 hours, integrating cannot restart. ("Err.014" is
displayed).
In this case, press the
SHIFT
→
RESET
keys to reset integrating data. (RUN
indicator off)
(8) When the GP-IB setting is "Pr." (printer mode), and a GP-IB listen-only
printer is connected, at the same time that integration values start to be sent
to the printer, measurement values can be printed at regular intervals. If,
however, communications are lost because of any fault, "Err. 023" is
displayed. Refer to Section 4.8, "Setting the Printer Output."
(9) When using the RS-232C interface, set the unit to printer mode and connect
RS-232C printer, measuring value are able to print according to every certain
interval simultaneously as starting integration. Refer to Section 4.8, "Setting
the Printer Output." If, however, communications are lost because of any
fault, "Err. 023" is displayed.
(10) When doing system resetting, integrating is stopped and the equipment is
reset to initial condition. For system resetting refer to Section 6.2, "System
Resetting."
(11) When the power is cut off during integrating, integration starts again after
returned. If the interface is Pr. (printer) mode, the data, integrate elapsed
time, and comment "POWER FAILURE" are printed out.
To Next Page
Loading...
