Hioki 3541 - Page 80

5.14 Reset Function
74
Initial Factory Default Settings
Description Default Description Default
Measurement Function Resistance Trigger Source Internal trigger
Resistance Measurement
Range
AUTO Line Frequency 60 Hz
LP Resistance Measurement
Range
AUTO Key Beeper ON
Zero-Adjust OFF Key-Lock OFF
Zero-Adjust Value 0 Comparator OFF
Temperature Correction/
Conversion
Temperature
Correction
Comparator Mode Hi/Lo
TC/∆ t OFF Comparator Upper Threshold 0
Temperature Correction Ref
Temp.
20°C Comparator Lower Threshold 0
Temperature Correction
Coefficient
3930 ppm Comparator Beeper HL
Temperature Conversion
Initial Resistance
0 m
Ω BIN OFF
Temperature Conversion
Initial Temperature
23°C BIN Enable/Disable All Disabled
Temperature Conversion
Constant
235°C BIN Mode All Hi/Lo
Statistical Calculation
Functions
OFF BIN Upper Threshold All 0
Delay AUTO BIN Lower Threshold All 0
Delay Time 0.000 s Interface RS-232C
Sampling Rate SLOW2 Print interval 0
Averaging Function OFF BIN/BCD Output BIN Output
Average Times 2 Error Output Async
Offset Voltage Compensation OFF Input Terminals A
Self-Calibration AUTO Temperature Sensor
Pt/ Analog /RS-232C
Pt
Continuous Measurement ON Analog Temperature
Measurement Constants
T1: 0°C T2: 500°C
V1: 0 V V2: 1 V