Hioki 3541 - Device-Specific Commands

123
8.6 Message Reference
8.6.2 Device-Specific Commands
(1) Event Status Register
Set and Query Device-Specific Event Status Enable Registers ESER0 and
ESER1
ESER0
Syntax
Command
Query
Response
:ESE0 <0 to 255 (NR1)>
:ESE0?
<0 to 255 (NR1)>
Description
Command Sets the mask pattern in Event Status Enable Register 0 (ESER0) for
the Event Status Register.
Note
Data initializes to zero at power-on.
ESER1
Syntax
Command
Query
Response
:ESE0 <0 to 255 (NR1)>
:ESE1?
<0 to 255 (NR1)>
Description
Command Sets the mask pattern in Event Status Enable Register 1 (ESER1) for
the Event Status Register.
Note Data initializes to zero at power-on.
128 64 32 16 8 4 2 1
bit 7bit 6bit 5bit 4bit 3bit 2bit 1bit 0
BIN1 BIN0 ERR Hi IN Lo INDEX EOC
128 64 32 16 8 4 2 1
bit 7bit 6bit 5bit 4bit 3bit 2bit 1bit 0
BIN9 BIN8 BIN7 BIN6 BIN5 BIN4 BIN3 BIN2
Read Device-Specific Event Status Registers ESR0 and ESR1
Syntax
Query
Response
:ESR0?
:ESR1?
<0 to 255 (NR1)>
Note
Executing ESR0? clears the contents of ESR0.
Executing ESR1? clears the contents of ESR1.