Hioki LR8431-20 - Loading Data on the Memory Hilogger; Loading a Setting Configuration

6.4 Loading Data on the Memory HiLogger
103
3
6
Chapter 6 Saving & Loading Data
Previously stored binary waveform data, captured screen images and saved
setting configurations can be reloaded into the Memory HiLogger (p.91)
Setting configurations saved in the Memory
HiLogger’s memory or on a CF
card or USB flash drive can be reloaded.
See: "Saving Setting Configurations" (p. 102)
6.4 Loading Data on the Memory HiLogger
Loading a Setting Configuration
Select the [Setting]
Screen.
Select [Load Set.].
1
2
Apply
Select the configuration
file to load.
(CONFnnnn.SET)
Memory HiLogger settings are reconfigured to those in the loaded configuration file.
Apply
The loading dialog appears.
3
Select whether to load a set-
ting configuration from
LR8431-20’s memory or CF
card or USB flash drive.
Apply
(If you selected [CF Card/USB
flash drive]
)
When Loading from CF card or USB flash drive
Configuration files stored in the [HIOKI_LR8431]-
[CONFIG] folder on the CF card or USB flash drive
are displayed.
When Loading from Memory HiLogger Memory
The list of configurations stored in Memory
HiLogger memory is displayed.
4
(If you selected [Memory])
Select [Load] for the con-
figuration you want to load.
Apply
To automatically load settings data (auto-setup)
Settings data saved under the filename “STARTUP.SET” in the “HIOKI_LR8431”-”CONFIG”
folder will be loaded automatically when the instrument is turned on. If settings have been saved
on both the CF card and USB flash drive, the CF card’s settings will take precedence. (“STAR-
TUP.SET” may not be loaded from USB flash drives that take a long time to be recognized.)