3.4 Setting Configuration 2 – Input Channel Settings
49
3
3
Chapter 3 Setting before Measurement
Configure the input channel settings on the [CH] screen. You can make these
settings while viewing input signal amplitude on the level monitor.
There are two general types of input signals, analog channels CH1 – CH10
a
nd pulse
channels P1 to P4. The analog channels can be used to measure
voltage and temperature (with thermocouples), and the pulse channels can be
used for pulse counting (integration) and revolution measurement.
Settings can be changed while viewing all channel settings on the [Range],
[Sc
a
ling], [Trig & Alm], and [Comment] screens.
In this example, settings are made on the [CH] screen while viewing the level
mo
nitor
.
You can specify recording criteria with the input setting
s
to control recording,
or to output alarm signals. See Chapter 4, "Specifying Criteria for Measu
re-
ments (Triggering, Alarm and Timer)" (p. 67) for details.
3.4 Setting Configuration 2 – Input Channel
Settings
Analog channels Pulse channels
"Voltage Measurement Settings" (p. 50)
"Integration (Count) Measurement Settings"
(p. 53)
"Temperature Measurement Settings" (p. 51) "Revolution Measurement Settings" (p. 54)
Select the [CH] screen.
Move to a setting item.
Apply
Open the setting options
for the item to be set.
Select from the listed op-
tions.
1
2
Level monitor (p. 24)
Use the CH / keys to change
the selected channel.
To Next Page
Loading...
