5.1 Viewing Waveforms
82
When measuring or displaying an existing waveform,
use the
SCROLL/CURSOR keys to scroll.
You can scroll to any part of a waveform while mea-
suring. To return to the current waveform position,
move the
selection cursor to [Trace] at the lower right
of the screen, and press the ENTER key.
To jump to the start or end of a waveform, hold the
ESC key while scrolling.
From the scroll bar you can verify the relative position
and size of the displayed portion of a waveform within
the ov
erall recorded waveform.
The width of the currently displayed time span indica-
tor within the scroll bar depends on the time base
(time per horizontal division) setting, even when the
recording length is unchanged.
5.1 Viewing Waveforms
Scrolling Waveforms
Screen Display
Earlier
Later
If internal memory becomes full when measuring with [Cont] set to [On], recording
continues by overwriting the oldest acquired data. Therefore, even when scrolling
earlier parts of waveforms, the overwritten data is lost.
Internal Memory (max. recording length): scrollable viewing time span
Erased Data
Verifying Waveform Display Position
Screen Display Range
Whole Waveform
To Next Page
Loading...
