2.1 Using the Battery Pack (Option)
29
3
2
Chapter 2 Measurement Preparations
Regardless of whether the Memory HiLogger is on or off, the battery pack
recharges whenever the Z1005 AC Adapter is plugged in to a power source.
Therefore, charging is provided by merely keeping the battery installed in the
Memory HiLogger.
Install the Battery Pack
Charge the Battery Pack
Required tool:
One Phillips screwdriver
(No.2)
Important
Disconnect the AC adapter when installing the battery pack.
Battery Compartment
Cover
1
Place the Memory
HiLogger face down, and
remove the battery com-
partment cover screw
and cover.
2
Connect the plugs of
the battery pack to the
connectors and insert
the battery pack with
the label side up.
Replace the bat-
tery compartment
cover and screw.
3
Pull the battery pack plug straight out to remove the battery pack.
Make sure that the
cables are not
pinched.
2
Be sure to properly
seat the connectors.
1
Connect the power cord to
the inlet socket on the AC
adapter.
1
2
Connect the output plug of the
AC adapter to the instrument.
Plug the power cord into the mains outlet.
3
Refer to 2.2, "Connecting the AC Adapter" (p. 30) for details about the AC adapter.
The CHARGE LED lights red
when charging begins.
Charging is finished when the
CHARGE LED turns off.
To Next Page
Loading...
