8.3 Making System Settings
125
3
8
Chapter 8 System Environment Settings
This procedure resets all settings to their factory defaults.
The system is reset by pressing and holding the START
/STOP key while turning the
Memory HiLogger POWER switch on.
For details about the factory default settings, see Appendix 5, "List of Default Set-
tings" (p. A10).
Initializing all settings (reset all)
• If you wish to reset settings stored in the instrumentÅfs memory as well as lan-
guage and USB mode settings, turn on the instrument while holding down the
SAVE
key and the START/STOP key.
• When the power is switched on, the language selection screen will d
isplay for you
to choose the language you wish to use.
• After resetting all settings, the USB mode will be set to USB Memory.
Initializing the Memory HiLogger (System Reset)
1
2
3
Select the [System]
Screen.
Select [Initialize].
Apply
A confirmation dialog
appears.
Select [Yes].
Apply
Initialization proceeds.
Settings stored in the instrument’s memory and language and USB mode settings will not
be reset.
To Next Page
Loading...
