2.3 Connecting Measurement Cables to the Memory HiLogger
32
Connect the voltage and temperature measurement (thermocouple) leads to
the analog input terminals.
Connecting Measurement Leads or Thermocouples (for voltage
or temperature, respectively)
Using the screwdriver, loosen the terminal
block screws, insert the bare ends of the leads,
and tighten the screws.
Connect to the
measurement
object.
Analog Input Terminals
1
2
When applying 4 - 20 mA input current
Connect a 250 shunt resistor as shown.
Tools required: Phillips screwdriver (for M3 screws)
(For details on instrumentation control equipment measure-
ments, see p. 50 .)
To Next Page
Loading...
