Hioki LR8431-20 - Chapter 7 ; Numerical Calculations; Calculation Methods

7.1 Calculation Methods
113
3
7
Chapter 7 Numerical Calculations
Calculations can be applied to measured data. Six types of numerical calculation are
available, four of which can be applied at the same time. Refer to 7.2, "Numerical
Value Calculation Expressions" (p. 117) for details of the calculation methods. You
can specify the measurement time span over w
hich calculations are
to be applied (p.
116).
Types of calculations
Two methods are available for applying calculations, as follows.
Numerical 
Calculations
Chapter 7
7.1 Calculation Methods
• Average value
Average value of waveform data
• Peak value
Peak-to-peak value of waveform data
•Maximum value
Maximum value of waveform data
• Minimum value
Minimum value of waveform data
• Time to maximum value
Time elapsed from the start of measurement to the maximum
value
• Time to minimum value
Time elapsed from the start of measurement to the minimum
value
Configure numerical calculations before
starting measurement. Calculations are per-
formed automatically after measurement (p.
114).
Auto Calculation
(Setting Screen)
Set Numerical Calculation to [On],
and select the calculation types
To save calculation results automatically
(Setting Screen)
Enable Auto Save (p. 97)
Start and finish measuring
Analyze (p. 81)
Configure numerical calculations after
measurement (p. 115).
Calculating After Measuring
End of Measurement
(Setting screen or Waveform screen)
Set Numerical Calculation to [On],
and select the calculation types.
(Waveform Screen)
Execute Calculations
Analyze (p. 81)