3.5 Display Settings
56
Configure how each channel is displayed, as needed. These settings can be
changed on the Numerical/Waveform screen after measurement.
Different display colors can be selected for each input channel waveform.
The vertical display range and zero position
can be specified for each channel.
The magnification setting determines the
display
ed range
. Waveforms are expanded
or compressed vertically relative to the cen-
ter of the screen.
Magnification and zero-pos
ition s
ettings are
ignored when the display range is defined
by upper and lower limits.
In the 1-5V range of a voltage measure-
ment and in integration measurement,
[Position] cannot be specified.
3.5 Display Settings
Selecting Waveform Display Color
Select from the waveform display color set-
ting options.
Setting options:Off ( x ), 24-color
Specifying Vertical Display Range by Magnification and Zero
Position (vertical axis expansion/compression)
Zero Position: 50%
25%
0 V
100%
0%
50%
0 V
25%
Normal Display
Magnified
Display (x2)
1 Select [Position] for the [Type] setting options.
2 Select from the [Zoom] setting options.
Setting options:
x100, x50, x20, x10, x5, x2, x1, x1/2
( default setting)
3 Set the desired zero position [0 pos] as a
percentage of screen height.
Setting options:
-50 to 150% (with x1 m
agnification)
1
2
3
Change 1’s digit
The expansion/com-
pression range de-
pends on the selected
magnification.
To Next Page
Loading...
