3.7 Viewing All Channel Settings in a List
63
3
3
Chapter 3 Setting before Measurement
The CH1 and P1 channel settings can be copied to other channels.
The display of all waveforms can be hidden, and all waveform display colors
can be se
t to defaults.
Batch Copying Channel Settings
Select the screen showing the channel to copy.
[Range], [Scaling], [Trig & Alm]
Select [Batch Proc].
1
2
Apply
The selected items are displayed.
3
Select the desired action.
Apply
• [Copy settings of CH1 to all
other analog channels] :
Copy the settings from channel
1 to channels 2 through 10.
• [Copy settings of P1 to all
other pulse channels] :
Copy the settings from channel
P1 to channels P2 through P4.
Except for the following, the settings dis-
played on the screen are copied.
• Waveform display color
• Input type (although this can also be
copied from the [Range] screen, p. 62 )
Batch Setting Waveform Display/Hide and Waveform Color Set-
tings for All Channels
This setting is only available on the [Range] screen.
Select [Batch Proc].
1
2
Apply
The selected items are displayed.
Select the desired action.
Apply
• [Set all analog channels color off]:
Sets all channel waveforms to be hidden.
• [Set all analog channels color default]:
Sets all channel waveform colors to their defaults.
To Next Page
Loading...
