Hioki LR8431-20 - Selecting Display Options; Displaying Gauges; Displaying Cursor Values

5.2 Selecting Display Options
84
A gauge corresponding to the measurement range of
each channel can be displayed at the left side of the
scree
n, for confirming measurement values. The color of
the gauge matches the waveform display color of its input
channel.
Press the
CH or key to display the gauges for other
channels. However, note that when measurement data is
displayed, only those
channels that are enabled (set to
On ) for measurement can be selected.
Time difference and potential difference (and when scaling
is enabled, scaling values) can be read as numerical val-
ues using the A/B cursors.
5.2 Selecting Display Options
Displaying Gauges
1
2
Select the Waveform
Screen.
Gauge
Select [Gauge+Wave].
Apply
Displaying Cursor Values
A
B
About Cursor Values
Cursor Type Example Cursor Value
Trace
Cursors
Displays the time and measurement values at the A/B cur-
sors, or the time and measurement differences between
the A/
B cursors.
Displays the intersections (trace points) of cursors and
wave
form
s. (the intersections of waveform traces of se-
lected channels)
Vertical
Cursors
Displays the time and frequency values at the A/B cursors,
or th
e time and frequency differences between the A/B cur-
sors.
Horizontal
Cursors
Displays the measurement values at the A and B cursors
for th
e selected channel(s), or the difference between A/B
cursor values.
A/B cursors can be enabled for any channel.
A
B
B-A
B-A
AB
B-A
A
B
B-A