Hioki LR8431-20 - Page 4

Contents
ii
Chapter 3
Setting before Measurement_______________ 37
3.1 Pre-Operation Inspection ....................................... 37
3.2 Operating Flow Overview ....................................... 38
3.3 Setting Configuration 1 – Recording Settings ..... 42
 Specify the Recording Interval .........................................42
 Setting the Display Time Base (horizontal axis 
magnification,set as needed) ...........................................43
 Selecting the Recording Start/stop Method .....................44
 Set the Recording Length for Repeated or One-time 
Recording .........................................................................45
 Enable Digital Filtering (noise suppression) (as needed) 45
 Automatic Saving .............................................................46
 Replacing Removable Storage During Real-Time Saving 48
3.4 Setting Configuration 2 – Input Channel Settings 49
 Voltage Measurement Settings ........................................50
 Temperature Measurement Settings ...............................51
 Integration (Count) Measurement Settings ......................53
 Revolution Measurement Settings ...................................54
3.5 Display Settings ...................................................... 56
 Selecting Waveform Display Color ..................................56
 Specifying Vertical Display Range by Magnification and 
Zero Position (vertical axis expansion/compression) .......56
 Specifying the Vertical Display Range by Upper and 
Lower Limits (expansion/compression) ............................57
 Converting Units (Scaling function) ..................................58
3.6 Entering Comments ................................................ 60
3.7 Viewing All Channel Settings in a List .................. 62
 Batch Copying Channel Settings .....................................63
 Batch Setting Waveform Display/Hide and Waveform 
Color Settings for All Channels ........................................63
 Initializing Settings (to factory defaults) ...........................64
 Aligning Zero Positions on the Grid .................................64
 Display Celsius (°C) temperature values as 
Fahrenheit (°F) .................................................................65