6.3 Displaying Phase Relationships ([VECTOR] Screen)
101
Chapter 6 Monitoring Instantaneous Values (VIEW Screen)
6
Axis display
You can select whether to use a linear display (LINEAR) or logarithmic display (LOG) for the vector axis.
If you select the logarithmic display method, the vector is easy
to see even at low levels.
RMS/phase angle/content percentage display
Selects which value to display (RMS value display, phase angle display, or content percentage display). If
[Phase] is selected, you can also set the phase angle value display method.
Phase angle value display method
You can select the type of phase angle display. (This setting can be configured only when [Phase] is
selected.)
Setting this parameter to
[lag360] allows the display to be rotated clockwise 0° to 360°.
If
[lag360] is selected, you can also set the phase angle reference source.
Phase angle reference source
You can select the reference source (0°) to display the phase angle
value.
Setting Contents:( ∗ : Default setting)
LINEAR∗
Linear display
LOG Log Logarithmic display
When the 400 Hz measurement frequency is selected, harmonic analysis is performed up
to the 10th order, and inter-harmonic analysis is not available.
Setting Contents:( ∗ : Default setting)
Level∗
RMS
Phase Phase angle
Content Content percentage
Setting Contents:( ∗ : Default setting)
±180∗
lead 0 to 180°, lag 0 to -180°
lag360 lag 0 to 360°
U1∗
Uses U1 as the reference source.
I1 Uses I1 as the reference source.
U2 Uses U2 as the reference source.
I2 Uses I2 as the reference source.
U3 Uses U3 as the reference source.
I3 Uses I3 as the reference source.
To Next Page
Loading...
