13.6 Interface Specification
228
13.6 Interface Specification
USB Connector Series B receptacle
Method USB 2.0 (full-speed, high-speed), mass storage class
Connection destination Computer: Windows 7 (32 bit/64 bit) / Windows 8 (
32 bit/64 bit)
/ Windows 10 (32 bit/64 bit)
Connection Recognition of the SD memory car
d as a removable disk when
connected to a computer.
The instrument cannot be connected during recording (includ-
ing standby operation).
LAN Connector RJ-45
Electrical specifications IEEE 802.3-compliant Ethernet
Transmission method 100BASE-TX
Protocol TCP/IP
Functions
⋅ HTTP server function
(compatible software: Internet Explorer
®
Ver. 6 or later)
⋅ Remote operation application function
⋅ Measurement start and stop control functions
⋅ System configuration function
⋅ Event list function (capable of displaying event waveforms, event vec-
tors, and event harmonic bar graphs)
⋅ Data is manually acquired from the FTP server.
Maximum cable length 100 m
RS-232C Connector D-sub 9 pin
Method RS-232C “EIA RS-232D”, “CCITT V.24”, “JIS XS101” compliant
Connection destination GPS box (cannot be connected to computer)
Functions Measurement and control using GPS-synchronized time
SD memory card Slot SD standard compliant
Compatible card SD memory card/ SDHC memory card
Functions
⋅ Saving of binary data (measured data / event data) (up to 9999 files)
Up to 100 files of measurement data can be saved on the same date.
⋅ Loading of binary data (measurement data/event data)
⋅ Saving of settings files (up to 102 files)
⋅ Loading of settings files (up to 102 files)
⋅ Saving of screen copies (up to 99,999,999 files)
⋅ Loading of screen copies (up to 102 files)
⋅ Deleting of files
⋅ Formatting of SD memory cards
Media full processing Saving of data to SD memor
y card is stopped (time series data is stored on
a first-in, first-out basis.)
To Next Page
Loading...
