Hioki PQ3198 - Displaying Trends

7.2 Displaying Trends
114
This section describes how to generate a time series display of values calculated internally every 200 ms
each TIME PLOT interval. When using one or two screens, the maximum, minimum, and average values
during the TIME PLOT interval are shown.
7.2 Displaying Trends
Select with the F key.
To change the displayed characteristic,
channel, waveform, or measured value
(when displaying [1-Screen] or [2-
Screen] screen) (p.115)
To change the displayed characteristic
(when displaying [Energy] screen) (p.117)
To enlarge or reduce the graph (p.118)
To view the value and time over the
cursor (p.119)
To scroll through display data (p.119)
To search for an event (p.120)
[TIME PLOT]
screen
[Trend]
[1-Screen]
Example: 3P4W (3-phase, 4-wire)
When displaying
[2-Screen], you can
select two characteris-
tics to display.
[Trend]
[2-Screen]
[Trend]
[Energy]
Initial time in displayed data
(One interval time prior to that displayed
for cursor measurement)
Final time in displayed
data
HIOKI PQ3198A961-02