13.3 Screen Specifications
214
Operating modes Four modes: [Setting], [Recording] , [Waiting], and [Analyzing]
A group of screens including [SYSTEM], [VIEW], [TIME PLOT], an
d [EVENT]
displays groups exists for each mode.
[Setting]
(Setting)
Instrument has been turned on, and there is no data stored internally.
[Waiting]
(Waiting)
Effective from the time the START/STOP button is pressed until the recording
start time.
[Recording]
(Recording)
Recording has started, and measurement data is being saved on the SD mem-
ory card.
[Analyzing]
(Analyzing)
Recording has stopped, and the instrument's internal measurement data can be
analyzed.
13.3 Screen Specifications
[SYSTEM] Settings can be changed, and measured values are updated approxi-
mately once every 0.5 s.
[VIEW] Screen updated approximately once every 0.5 s
[TIME PLOT]
None
[EVENT] None
START LED Off
[SYSTEM] Settings cannot be changed, and measured values are updated approx-
imately once every 0.5 s.
[VIEW] Screen updated approximately once every 0.5 s
[TIME PLOT]
Standby display with time series graph
[EVENT] Standby display
START LED Flashing
[SYSTEM] Settings cannot be changed, and measured values are updated approx-
imately once every 0.5 s.
[VIEW] Screen updated approximately once every 0.5 s
[TIME PLOT]
Screen updated every TIME PLOT interval
[EVENT] Screen updated every time an event occurs
START LED On
[SYSTEM] Settings cannot be changed, and measured values are updated approx-
imately once every 0.5 s.
[VIEW] Analysis of event specified on the [TIME PLOT] or [EVENT] screen
[TIME PLOT]
Time series graph display
[EVENT] Event display
START LED Off
To Next Page
Loading...
