7.5 Displaying Flicker Values in Graph and List Form
133
Chapter 7 Monitoring Fluctuations in Measured Values
(TIME PLOT Screen)
7
This section describes how to read the Pst and Plt measured values every 10 minutes.
During recording, the X- and Y-axis are automatically scale
d so that the full time series graph fits on the
screen. Once recording has stopped and the X- and Y-axis scale has been changed so that the wave-
forms do not fit on the screen, you can scroll through the time series graph by moving left, right, up, and
do
wn.
Reading the value above the cursor (Cursor measurements)
[Cursor]
Move the vertical
cursor left and
right to read the
display value.
Cursor value
Top: Pst measured value
Bottom: Plt measured value
Cursor
Cursor time
Cursor value
Scrolling through waveforms
[Scroll]
Scroll through the
graph
Scroll bar
Display scope
Scroll bar
Display scope
Scroll bar
Display scope
All measurement data
Cursor position
• The display scope on the scroll bar
(shown in white) illustrates which
range of all measurement data is
being shown on the screen.
• The cursor on the scroll bar shows
where the cursor is located relative to
all measurement data.
To Next Page
Loading...
