Redundancy
140
8.2
HIPER-Ring
RM Web L3P
Release
4.1
03/08
Note: Deactivate the Spanning Tree protocol for the ports connected to the
redundant ring, because the Spanning Tree and the Ring Redundancy work
with different reaction times.
The “VLAN” frame enables you to assign HIPER-Ring Version 2 to a VLAN.
If VLANs are configured, then in the “VLAN” frame you select
- VLAN ID 0, if the MRP-Ring configuration is not to be assigned to a
VLAN.
Note the VLAN configuration of the ring ports. Then select for the ring
ports
- VLAN ID 1 and
- VLAN membership U in the static VLAN table
- a VLAN ID >0, if the MRP-Ring configuration is to be assigned to this
VLAN.
Select this VLAN ID in the MRP-Ring configuration for all devices in this
MRP-Ring.
Note the VLAN configuration of the ring ports. For all ring ports in this
MRP-Ring, select
- this VLAN ID and
- VLAN membership U in the static VLAN table.
Select the desired value in the “Ring Recovery” frame for the device for
which you have activated the redundancy manager.
Note: Settings in the “Ring Recovery” frame are ineffective for devices that
are not the redundancy manager.
Note: If selecting the smaller value for the ring recovery does provide the ring
stability neccesary to meet the requirements of your network, you select
500 ms.
Activate the function in the “Operation” frame.
Now you connect the line to the ring. To do this, you connect the two
devices to the ends of the line using their ring ports.
To Next Page
Loading...
Need help?
General
