Redundancy
144
8.3
Redundant coupling
RM Web L3P
Release
4.1
03/08
Note: One-Switch coupling: The redundancy function is assigned to the
Switch via the “STAND-BY” setting in the DIP switch, or via the
Management.
Note: Two-Switch coupling: The redundancy function is assigned to the
Switch in the redundant line via the “STAND-BY” setting in the DIP switch,
or via the Management.
Note: Some devices have a DIP switch, with which you can choose be-
tween the software configuration and the DIP configuration. If the soft-
ware configuration is set, the other DIP switches have no effect.
Note: The choice of configuration primarily depends on the topological
conditions and the desired level of safety.
Note: For redundancy security reasons, a combination of Rapid Span-
ning Tree and Ring/Network Coupling is not possible.
To Next Page
Loading...
