Operation Diagnosis
212
9.13
Syslog
Basic Configuration
Release
6.0
07/2010
9.13 Syslog
The device enables you to send messages about important device-internal
events to up to 8 Syslog servers. Additionally, you can also include SNMP
requests to the device as events in the syslog.
Note: You will find the actual events that the device has logged in the “Event
Log” dialog (see page 215 “Event Log“) and in the log file (see on page 207
“Reports“), a HTML page with the title “Event Log”.
Select the Diagnostics:Syslog dialog.
Activate the syslog function in the “Operation” frame.
Click on “Create”.
In the “IP Address” column, enter the IP address of the syslog server
to which the log entries should be sent.
In the “Port” column, enter the UDP port of the syslog server at which
the syslog receives log entries. The default setting is 514.
In the “Minimum level to report” column, you enter the minimum level
of seriousness an event must attain for the device to send a log entry
to this syslog server.
In the “Active” column, you select the syslog servers that the device
takes into account when it is sending logs.
To Next Page
Loading...
Need help?
General
