20
MACH 100
Release
07/09
2 Assembly and start-up
The devices have been developed for practical application in a harsh indus-
trial environment. The installation process is correspondingly simple.
On delivery, the device is ready for operation.
The following procedure has been proven to be successful for the assembly
of the device:
X Unpacking and checking
X Installing the media modules
X Installing the SFP modules
X Signal contact
X Installing the device and grounding
X Supply voltage
X Startup
X Installing the data lines
2.1 Installing the device
2.1.1 Unpacking and checking
Check whether the contents of the package are complete (see page 38
„Scope of delivery“).
Check the individual parts for transport damage.
2.1.2 Installing the media modules
On delivery, the device is ready for operation.
The modules can be used in
X MACH 102-8TP basic device
X MACH 102-8TP-R basic device
See the ESD guidelines on page 8 and the safety instructions on page 7ff.
The media modules are hot-plug-compatible, which means that you can re-
place the modules with a module of the same kind during operation.
Note: If you are replacing media, e.g. removing a TX media module and plug-
ging in an FX media module in its place, the MACH 100 performs a warm
start.
To Next Page
Loading...
Need help?
General
