Loading/saving settings
54
3.1
Loading settings
Basic Configuration
Release
6.0
07/2010
3.1 Loading settings
When it is restarted, the device loads its configuration data from the local
non-volatile memory, provided you have not activated BOOTP/DHCP and no
ACA is connected to the device.
During operation, the device allows you to load settings from the following
sources:
X the local non-volatile memory
X from the AutoConfiguration Adapter. If an ACA is connected to the device,
the device automatically loads its configuration from the ACA during the
boot procedure.
X a file in the connected network (setting on delivery)
X a binary file or an editable and readable script on the PC and
X the firmware (restoration of the configuration on delivery).
Note: When loading a configuration, do not access the device until it has
loaded the configuration file and has made the new configuration settings.
Depending on the complexity of the configuration settings, this procedure
may take 10 to 200 seconds.
To Next Page
Loading...
Need help?
General
