Hirschmann RS20 User Manual

Loading/saving settings
60
3.2 Saving settings
Basic Configuration
Release 6.0 07/2010
Note: After you have successfully saved the configuration on the device, the
device sends an alarm (trap) hmConfigurationSavedTrap together with
the information about the AutoConfiguration Adapter (ACA), if one is
connected. When you change the configuration for the first time after saving
it, the device sends a trap hmConfigurationChangedTrap.
Note: The device allows you to trigger the following events when the
configuration stored on the ACA does not match that in the device:
X an alarm (trap) is sent (see on page 179 “Configuring Traps“),
X the device status is updated (see on page 182 “Configuring the Device
Status“),
X the status of the signal contacts is updated (see on page 185 “Controlling
the Signal Contact“).
3.2.2 Saving to a file on URL
The device allows you to save the current configuration data in a file in the
connected network.
Note: The configuration file includes all configuration data, including the
password. Therefore pay attention to the access rights on the tftp server.

Hirschmann RS20 Specifications

General

Mounting	DIN Rail
Operating Temperature	-40°C to +70°C
Protection Class	IP30
Switching Technology	Store-and-Forward
Product Type	Industrial Ethernet Switch
Port Details	10/100 Mbps Ethernet ports
Switching Capacity	3.2 Gbps
MAC Address Table	8k
Management	Web, SNMP
Redundancy	MRP
Ports	8 or 16